BMW REMOTE MAKER

x-gate

Member
Hello,

i program smart key for BMW CAS3 with pcf7945 and key start vehicle
but, the remote does not work.

Please find attached, first dump read and dump generated after programming.
 
Send me files in prvaty mail .
Tango1V41 use ? PCF7945-Philips ?
Don't posible use PCF7945C05 , it is different from PCF7945-Philips !
In thise moment Tango don't support .
Probably next month support PCF7945C05 .

Best Regards
Lyubomir
 
Hello,

Is there any difference in the BMW remote control data of American (315Mhz) and European (868Mhz)?

I check with my friend using Hitag2 programmer from PAsoft V1.059 and it programmed CAS3 868Mhz
(PCF7945) and remote keys works fine and key starts vehicle.

But, when he program CAS3 smart key 315Mhz (PCF7945) remote does not work, but key starts vehicle.

Is it not possible, there is some difference in the remote control data?

I have sent the dump for E70 CAS3 2008 American Model to Lyubomir and i hope he can find the
solution.

Regards,
X-gate.
 
Hi George,

why are you asking everybody the same question after you have been answered many times. I told you before and I am telling yo now that 315 and 868 are different keys as a remote for same car but same as a transponder to start the car.
 
Use 1V42 , if have BMW CAS remote maker .
Then load file from CAS see new buton > Remote frequency .
Press thise buton and see what key need thise car .
All next versions software Tango is beter and beter ...
 
HI EVERYBODY ,

FOR ALL USERS OF TANGO ,THE TANGO DEVICE TESTED ON ALL BMW MODELS WITH CAS WITH KEY ID 7943 AND 7944

WITH AN USED KEY ,TESTED ON USA AND EUROPEAN MODEL,

WORK 100 PERCENT

GOOD LUCK ;)
 
Back
Top