4d clone bugs

D

drugowaz

Member
Hi.
Recently noticed problems with 4D cloning.

Kawasaki key 4d
Today ford mondeo id63 09year.

Reads chip decoding procces runs but in last phase all hanging up and nothing desctop freezes.

Had to clone with other tool.

Can admin check on this?

Before few earlier updates all was good. No headacke.

Using xp sp3
 
Today again a bug.
Corrola verso 2007 d4 a slot key. Not smart.
Tango wont even read detect chip. Tried every position of key.
Again was cloned with other tool in 1 minute. Detected as 4d id70 master key
 
If Tango doesn't detect a 4D transponder, most probably you have damaged your programmer,
or your PC USB port doesn't work correctly.
Just tested cloning ID70 and several other 4D configurations for cloning (including Corolla) on a randomly picked Tango, decodes and clones correctly with current software
on all allowed for cloning transponders.
 
I dont think its damaged.
If i put one 4d say ford it detects it. Put toyota no detection.

Programmer always in safe hard case box with silicium bags avoid moisture. Im saving it very carefully.

As this is first time it didnt decent 4d chip

Few weeks ago did 2 same corrola keys. All good.
 
The tests we performed showed us that in current software there are no bugs or problems as far as 4D transponders (Toyota and others) are concerned.
In the light of this the problem you have is either caused by some damage on your Tango, or problem with its connection to PC ( be it faulty USB port, not well contacting cable, corruption of the OS, etc..... ).
 
You must log in or register to reply here.
Back
Top