Orange5 read error

I

issam

New member
hi,
when i try to read hc05 or hc08 i do skip (skip ok )
when i do read for the first time ( no echo ) read error
when i press read for the second time its read ok is this normal or i have an problem with my orange5 ?
i have software 30r1.
best regards.
Issam
 
hi,
sorry Sir but i tried al the type of 05x32(1d69j.0d69j) 08x32 (4j74y,...)
it seems the it should press read 2 times after skip to read. 1st time error 2nd time read succesfull, the same for write command.
i have omiga, it works good .\
best regards
Issam
 
hi.
i did the test hers the result
USB TX speed: 260047
USB RX speed: 315076
Vcc USB: 5.05V (99%)
UART: Ok

Hardware Ok
best regards
issam.
 
Hi

Realy strange , test ok , power too .
I test 5 pcs Orange-5 whit 2 differnt computers whit this mask
no see any problem .
 
hi,
anyway its reading and writing doesn't matter if i read it from the first click ,
thank you ,
Your help and Support are highly appreciated
Best Regard,
 
Hi

4J74Y form EZS realy is hard and have monitor ROM secured .
But Omega and Orange-5 skip whitout any problem .
(7)05X16 ...X32 secured , too hard and have prescaler iside
recomende be carefuly becouse possible delete contens
 
You must log in or register to reply here.
Back
Top