i read this mask at omega QFP64 hc 05B/X adapter board many times without any problems. used skip sec and after boot ok read. yesterday my omega destroy both content from one mercedes ezs. i have two adapter boards and same at the both. after that i write both mcu with new contents and read it well. no more solder or desolder write and read at same adapter boards where they put first time. attached one of two destroyed dumps. second dump i eresed but similar as first. little bit bytes of top content, down empty. am i do something wrong or just happened.This has caused much more work and I'm no longer safe in my omega. mr Ljubomir can you look my dump and tell me possible reasons?
thanks in advance
thanks in advance