Need pin for VW Polo

[bujar2]

I have to make a key for VW polo 2002
I read pin code with T300 and i get 6136
I read pin code with vag tacho and i get 0677

I try both of them but it saying acess deied turn ignation OFF

Here is the dump that i read with vag tacho if anyone could find me the pin code

THanks

 

[Vladko]

PIN code 0677 is correct.Try to wait 10min. with ignition on,and then try with pin code.

 

[bujar2]

i try to wait 10 minuts but didn't work
becouse somebody try before me with another pin code and i think the car will not accept new keys . i will try tomorrow it shuld work 100 % i just wanted to know if my pin is right

THANKS friend

 

[autodiagservices]

hello m8,
any success yet? if not do you have VCDS? try out the procedure below:
[Select]
[17 - Instruments]
[Meas. Blocks - 08]
Group 024
[Go!]
Any numbers displayed in fields 1-4 represent the time in minutes that must be counted down before the Immobilizer is unlocked. If the fields are all zero, skip to step below ****. If the Immobilizer is locked:
[Done, Go Back]
[Close Controller, Go Back - 06]
Do not switch off the ignition! Allow the car to sit for AT LEAST the number of minutes that were indicated by the display in Group 024


****

[Login - 11]
[Use 7-digit PIN/SKC]
Enter the 7-digit PIN, Date on which the PIN was generated by the dealer, along with the Workshop Code (WSC) and the Importer number of the dealer that generated the code.
[OK]


VAG-COM will validate the data you have entered and return you to the Login screen, where the Login Code will show as "XXXXX".
[Do It!]


[Adaptation - 10]
Enter 21 in "Channel Number"
[Read]
The "Stored Value" is the number of keys currently matched.
Enter "new value" of 0
[Save]
This clears out the old key-matchings.
Enter a "new value" corresponding to the total number of keys to be matched, including any existing keys
[Save]

[Done, Go Back]
[Close Controller, Go Back - 06]
Switch ignition off and remove key

Insert next key to ignition and switch ignition on again
The warning light for the Immobilizer will light up for ~2 seconds, then go out
Switch ignition off and remove key

Repeat with each key until all keys have been matched.

regards

 

[bujar2]

i try as you said but same problem ...
it take me 3 hour time but i finish it with sucess...
I let the car 1 day and try but still same than i read the Dash by obd and program a transponder with tango than write dump back in dash and all was OK car start ...

Thanks all