Search results

Hi, just curious if Scorpio team will add BA/BABA Toyota systems anytime soon ?

Hi, have a problem with tango key maker on 2014 Range Rover Evoque L538, when load dump into Tango it says "Unknown Version", I read it with VVDI PROG 9S12XEP100 1N35H, never had an issue with Range Rover (Hitag-Pro) BCM before, dump attached. P.S - this is not AKL or add key, I just want to...

Sorted elsewhere

Hi there, hope all's well Have a case Toyota Yaris 2012 with ID46 Valeo Smart Key System, this isn't a common one, quite rare, unfortunately Tango doesn't seem to support it, only TMPRO and such, if possible, I request the Tango team to add support for this system, thanks

Hi, so have a problem with key writing to FFRs, no matter which transponders I use, it will not allow to write - have tried 3 different original man keys and also aftermarket ID13, it will either say transponder not detected even though with autodetect it is detected as ID13 and data is able to...

Hi there team, hope all is good Have Mazda Biante, want to add key, can not add key by OBD, ECU has processor MPC5565 AND EEPROM 93C86, I have original 93C86 eeprom attached below - have marked this read 93C86 eeprom in image in yellow colour, labelled in green colour can't read what is...

Hello there So have a man TGA with all keys lost and eeprom 25C256, when load eeprom dump into tango, have message "this unit is not supported". . .

Hi all I have with me a Toyota ECU 1vd engine, land cruiser 200 series, now original ECU is dead, so need to obtain immo data from eeprom, now this ECU doesn't have normal rh86 or similar eeproms, it has labelled 16H YC - there is 2 eeproms of the same kind, now how do I read with orange ? What...

Hi there guys So have with me a Audi RS3 med17.1.1 ECU needed Mac, pin, CS and powerclass to clone ECU, but tango fails when press decode dump in the EDC17/MED17 DUMO EDITOR, it only shows actual vin but other data like Mac pin CS powerclass, not displayed. I used carlab's free utility to check...

Hi all, so I have with me an Iveco Stralis with all keys lost, and have read eeprom 25C640, and loaded dump, it loads up fine, now the thing is, I don't have the original iveco DST+ transponders, however I do have xhorse VVDI super chips, and have tried adding different ID62s and other similar...

Removed

Hi, was wondering if tango will ever extend its function(s) beyond just mostly keys, the tango developer team has done a great job bringing us new functions and improving functions, but extending tango's functionality I'm sure would somewhat bring a better overall audience. One such feature that...

Hello guys, recently tried to make a key for all keys lost on a BMW bike F800GS with the me17.2.4 type ECU equipped with tricore TC1793, from what I have read and know - tango's latest update supports TC1793 Motorrad but not sure if specifically the F800 GS. When I load the eeprom dump for the...