Search results

Hi, please post the data of the key so I can decrypt and change the ISN for you in DME, in the CRYPTO KEY field use this crypto key 91 75 0B 17 30 CF post both MAIN data and EEPROM file

Hi, sorry mate, I can't seem to find the virgin file on my computers unfortunately 😕 Also, you can't use that editor as your CAS is crypto and first needs to be decrypted to get ISN

No need to decrypt ISN since edc16 uses short isn and you can simply virgin the eeprom and adapt with launch Autel or ista, will send virgin file in a bit, post your ECU label ECU

You can do it yourself, there's a guide on Google 😉

BCM file is fine, Tango has a problem recognizing the dump. . . Kindly Tango team add support for this BCM if possible

Are you 100% sure truck is with immo ?

Hi, just curious if Scorpio team will add BA/BABA Toyota systems anytime soon ?

Any help here ?

Hi, have a problem with tango key maker on 2014 Range Rover Evoque L538, when load dump into Tango it says "Unknown Version", I read it with VVDI PROG 9S12XEP100 1N35H, never had an issue with Range Rover (Hitag-Pro) BCM before, dump attached. P.S - this is not AKL or add key, I just want to...

Read as MC68HC11F1

Worst case scenario - immo off in engine ECU . . .

Sorted elsewhere

Best way is to check for yourself, connect to it, and try to read data, it will tell you if possible or not

Hi there, hope all's well Have a case Toyota Yaris 2012 with ID46 Valeo Smart Key System, this isn't a common one, quite rare, unfortunately Tango doesn't seem to support it, only TMPRO and such, if possible, I request the Tango team to add support for this system, thanks

Hi, so have a problem with key writing to FFRs, no matter which transponders I use, it will not allow to write - have tried 3 different original man keys and also aftermarket ID13, it will either say transponder not detected even though with autodetect it is detected as ID13 and data is able to...

Hi there team, hope all is good Have Mazda Biante, want to add key, can not add key by OBD, ECU has processor MPC5565 AND EEPROM 93C86, I have original 93C86 eeprom attached below - have marked this read 93C86 eeprom in image in yellow colour, labelled in green colour can't read what is...

Hello there So have a man TGA with all keys lost and eeprom 25C256, when load eeprom dump into tango, have message "this unit is not supported". . .

Hi all I have with me a Toyota ECU 1vd engine, land cruiser 200 series, now original ECU is dead, so need to obtain immo data from eeprom, now this ECU doesn't have normal rh86 or similar eeproms, it has labelled 16H YC - there is 2 eeproms of the same kind, now how do I read with orange ? What...

Hi there guys So have with me a Audi RS3 med17.1.1 ECU needed Mac, pin, CS and powerclass to clone ECU, but tango fails when press decode dump in the EDC17/MED17 DUMO EDITOR, it only shows actual vin but other data like Mac pin CS powerclass, not displayed. I used carlab's free utility to check...

Hi all, so I have with me an Iveco Stralis with all keys lost, and have read eeprom 25C640, and loaded dump, it loads up fine, now the thing is, I don't have the original iveco DST+ transponders, however I do have xhorse VVDI super chips, and have tried adding different ID62s and other similar...