Search results

Does anyone know whereto open ECU to read eeprom ?

Can somebody assist with the PIN code from file Thanks Mark

I load the eeprom file but Tango says unknown version

Does anyone know where the eeprom is ?

Hello, i tried to make transponder for this ECU using TPX/EH2 and 4D60 but bike will NOT START Any info will be appreciated Thanks Mark

Can someone check this file if corrupt cannot load in Tango or Tmpro Thanks

Hello, I need to read 0K12Y HC908AZ32A , When I read with Orange data read is all AD AD AD .... Is there security SS code to read this processor ? Tango manual only shows 2L18M or 2J74Y Thanks Mark

Hello, When we load this file into Tango "unknown version " Is the file corrupt ? or does Tango not have this version ?

Hello, I have toyota Vitz Smart system , after reading C66 from ECU certification module and load to Tango Damaged dump is detected How do we restore this error . Can ECU cert. be reset ?? Continue with key programming ""detected keys are different types + Page 1 value has been detected "" 6...

I need pin code please VF7FCNFUC26647078 Thanks Mark

Hello, Is this a false eeprom on this ECU, when we read eeprom it is blank "0000" I there another location? Thanks Mark

Hello, Can anyone assist me to code this toyota immo ? 2013 Toyota Avanza with Daihatsu immo box

2006 ZX10R , please can someone give me picture to open this ECU to find eeprom I used Tango pic but NO eeprom thanks Mark

Can Tango make key for this bike ECU ?? Where do we cut open to read eeprom Thanks Mark

My Tango cannot read/recognise 7935 transponder , Tango will write new transponder perfect to start cars but if I try to check/verify /read transponder it says" transponder not detected "" Any help to repair this issue ?? Thanks

Hello, 2009 VW 17250 8ton Truck Do these VW trucks have Transponders ?? Thanks Mark

I have Immo box with 93LC56 , when I read as 8 or 16 bit Tango says unknown version Any ideas or can someone give me another dump file to use Can you use another immo box ?? Thanks Mark

Hello, I got Siemens VDO ECU with 95256 chip , read and Tango programs T5 transponder all OK . When I install back into Truck , and switch ignition ON Message on Speedometer " CODE INVALID Interlock Active "" When I remove ECU and read eeprom again the CHECK sum is different to Original...

I have 2 AAM , first one has 0G47Y and other 1D69J , but after reading and loading file to Tango only 0G47Y shows old keys used Attached 1D69J file , please see if this is full file or if corrupt Thanks

Hello, Can used BMW 7945/7952 etc... keys be unlocked ?? Tango can write 7942/44 used keys into white CAS , but what about newer types ?? Are there tools to do this ?? Someone told me it is possible , and done in Spain @ 20-40 euro , do they break open the keys to do it ?? Thanks Mark